404 Error - Page not found
Uh oh, looks like the page you are looking for has moved or no longer exists.
Uh oh, looks like the page you are looking for has moved or no longer exists.
Commercial hand dryers are engineered for continuous use, higher airflow, faster drying times (typically 10-15 seconds vs. 30-45 seconds for residential), and longer operational lifespans. They also support 110-127V or 200-240V electrical configurations on dedicated circuits, and most include certifications relevant to commercial installation (NSF, GREENSPEC, ADA). Residential hand dryers are not built for the duty cycles required in offices, schools, healthcare facilities, or other commercial settings.
The standard XLERATOR uses heated air to dry hands in 10-15 seconds at approximately 1450 watts. The XLERATOReco is the no-heat version, drying hands in 10 seconds at only 500 watts—approximately 65% less energy than the standard line. The XLERATOReco is specified for facilities pursuing LEED v4 credits, sustainability targets, or ESG reporting, and its lower wattage allows multiple units to install on a single electrical circuit—valuable for multi-stall restroom retrofits where the standard XLERATOR would require electrical upgrades. Both lines are GREENSPEC/BuildingGreen listed and made in the USA.
For most high-traffic commercial restrooms, yes. Excel Dryer reports up to 95% cost savings on hand drying vs. paper towels, factoring in paper purchase cost, restocking labor, and waste disposal. A typical commercial restroom spends $1,500-$4,000 per year on paper towels. Most facilities see full payback on a commercial hand dryer within 12-18 months of installation.
The Dyson Airblade V protrudes 4″ from the wall when surface-mounted, meeting ADA accessibility requirements without recessing. The Excel ThinAir series (TA-SB stainless and TA-ABS white) also protrudes 4″ and is engineered specifically for ADA-compliant installations. Standard XLERATOR and XLERATOReco models protrude further and may require recessing for ADA-compliant installations—refer to spec sheets and consult local accessibility codes for site-specific guidance.
Sound levels vary by model. The Dyson Airblade V operates at approximately 79 dB at 1 meter and is Quiet Mark certified by the Noise Abatement Society. The Excel ThinAir (TA-SB and TA-ABS) offers adjustable sound from 75 dB down to 67 dB—the lower setting is suitable for healthcare, hotels, and other noise-sensitive environments. XLERATOR models operate at approximately 90 dB at 4 feet, which is louder than these options. For hospitality, healthcare, and office settings, consider Quiet Mark certified or adjustable-sound models.
This concern most commonly applies to older warm-air dryers without filtration. Modern HEPA-filtered commercial hand dryers, such as the Dyson Airblade V, capture 99.97% of bacteria from incoming air at 0.3 microns before it reaches the user’s hands. The Airblade V is also certified by NSF International (P335) and HACCP International for use in food preparation environments. For hygiene-sensitive facilities, specify a HEPA-filtered model.
Commercial hand dryers are standard in office buildings, K-12 and higher education facilities, healthcare and dental offices, hotels and hospitality, restaurants and food service, government and municipal buildings, transit hubs, retail, and corporate campuses. The choice of model depends on traffic volume, sound sensitivity, ADA requirements, energy targets, and whether HEPA filtration is needed.
Most commercial hand dryers from major brands (Dyson, Excel Dryer) are engineered for 7-10+ years of continuous commercial use. HEPA filters in the Dyson Airblade V typically last 2-5 years depending on environment and usage—inspect filters periodically and replace when they appear gray or clogged. XLERATOR motors typically last 50% longer than conventional commercial dryer motors per Excel Dryer.